Product was successfully added to your shopping cart.
Chain sling load chart. Please only use this information for reference.
Chain sling load chart. The maximum working load limits are therefore set at the same values as the Triple Chain Slings of equal quality and size, and used with branches at the same angle of inclinations. Chain_Load_Chart_tnail. L. Jun 13, 2018 ยท This chart applies to general purpose chain slings made of Grade 80 and Grade 100 lifting chain and components manufactured to AS3775. Inspect sling for damage before each use. Are you looking for working load limit information for your Peerless Chain Sling? Use the attached table to determine Peerless WLL specs Working Load Limits chart for Uniform loading on SpanSet Round and Webbing slings Straight Lift Choke Lift Multi-leg 2 leg sling 0° to 45° Multi-leg 2 leg sling 0° to 45° with ends choked Multi-leg 2 leg sling 45° to 60° Chain & Sling Load Charts are A6 in size and provide the following useful information: Chains:Working load limits (tonnes) for Grade 100 & Grade 80 to EN 818. Refer to the chain chart on this page and the Efect of Angle chart in the General Information section of this catalog. Please only use this information for reference. jpg Slings:For Synthetic Web and Round Slings in (kgs) for normal use and equally loaded slings to EN1492-2. Consult sling load chart for capacity reduction due to sling angle or type of hitch used. Do not attempt to use sling above rated load and angle upon which it is based. Ensure safety and efficiency in your lifting operations. 2:2014 or equivalent international standards, and flat Sling HOOk 5/16" Eye Type Eye Type Sling Hook (9/32") 5/16" Eye Type Eye Type 1 -LEG CHAIN SLINGS Capacity in lbs (Grade 100) Master Link WORKING LOAD LIMIT CHART (W. 6. GRADE 100 CHAIN SLINGS - AS 3775 WORKING LOAD LIMIT (W. ) IN TONNES UNDER GENERAL CONDITIONS OF USE SINGLE LEG SLINGS CHAIN GRADE 100 CHAIN SLINGS - AS3775 WORKING LOAD LIMIT (W. L) O D ivalent International standards. A falling load may cause serious injury or death. The contact surface diameter divided by the rope diameter is designated D/d ratio as described in Fig. Here you will find key factors when calculating the working load limit (WLL) of chain slings, such as the angles of use, safe operating temperatures and grade. ) IN TONNES UNDER GENERAL CONDITIONS OF USE. For ratings of special purpose slings Learn safe use and understand the working load limits of chain slings with CERTEX. The symbols below represent load or support surfaces in contact with the rope sling. Read and understand these instructions before using sling. wtqiwfyrmnxuehoeqvedgqlduxsnnxwarhmxyhxhabthnoktzjheledq